Aroma composition of red wines by different extraction methods and Gas Chromatography-SIM/MASS spectrometry analysis

One hundred and one volatile compounds, reported in literature as powerful odorants of wine, were quantified by Gas Chromatography-Selective Ion Monitoring/Mass Spectrometry (GC-SIM/MS) in Primitivo, Aglianico, Merlot and Cabernet Sauvignon red wines. Wine samples were extracted by 3 different extraction methods: 1) separation of the alcoholic fraction from the aqueous phase by salting-out and subsequent extraction by liquid-liquid micro-extraction with 1,1,2-trichlorotrifluoroethane (Freon 113); 2) extraction by liquid-liquid micro-extraction with dichloromethane; 3) solid phase extraction (SPE cartridge: 800 mg of LiChrolut EN resin) with pentane-dichloromethane (20:1) and dichloromethane. The selection of the ion fragments used for quantification was directly performed on a red wine sample. For each compound the area of the corresponding peak was normalized respect to the peak of the internal standard and then interpolated in a calibration curve obtained analysing a model wine solution (water, ethanol, tartaric acid and known amounts of analytes and of internal standard). The methods showed a good linearity: r2>0.990, except for farnesol (isomer a and c), octanal, decanal, furaneol and phenylacetic acid with 0.966 < or = r2 < or = 0.990. The 7 most powerful odorants were: beta-damascenone, acetaldehyde, maltol, ethyl 2-methylbutanoate, ethyl 3-methylbutanoate, 3-methylbutanoic acid and acetal; 7 other slightly less important were: ethyl hexanoate, ethyl acetate, 1-octen-3-ol, butanoic acid, rose oxide, furaneol and sotolon. The Aglianico wines were characterised by the major fermentation compounds (esters, fatty acids and 2-phenylethanol), beta-damascenone, beta-ionone and linalool. The Primitivo wines were characterized by furaneol, methoxypyrazine, gamma-nonalactone and acetaldehyde, while Cabernet Sauvignon and Merlot wines principally by cask derivates (vanillin, (Z) 3-methyl-gamma-octalactone [(Z) wiskylactone], maltol and eugenol), some aldehydes and 3-isopropyl-2-methoxypyrazine.     

Two‐dimensional non‐close‐packed arrays of nanoparticles via core‐shell nanospheres and reactive ion etching

Nanosized PTFE/polystyrene core‐shell particles were prepared by seed emulsion polymerization technique starting from PTFE seeds of 20 nm. At the end of the reaction, no residual PTFE nor secondary nucleation was observed and by appropriately choosing the ratio between the monomer and the PTFE seed it was possible to obtain particles, with predetermined size in the range 60–100 nm, featuring an extremely narrow size distribution. These particles were successfully employed as building blocks for the preparation of large scale nanosized monolayers through the floating technique. Reactive ion etching was further applied to modulate the size characteristics of the resulting 2D ordered nanostructure. Although for relatively short RIE times a peculiar continuous morphology was observed in which the particles are interconnected through thin arms, on further increasing the RIE time a well‐organized 2D arrangement of particles with size of about 30 nm was obtained. Considering the shell as an expendable ordering and spacing tool, the use of core‐shell nanospheres allows a wide variety of controlled morphologies to be designed and prepared thus opening new perspectives for nanostructure fabrication processes through nanosphere lithography (NSL). Copyright © 2011 John Wiley & Sons, Ltd.     

Conformational analysis of quinine and its pseudo enantiomer quinidine: a combined jet-cooled spectroscopy and vibrational circular dichroism study

Laser-desorbed quinine and quinidine have been studied in the gas phase by combining supersonic expansion with laser spectroscopy, namely, laser-induced fluorescence (LIF), resonance-enhanced multiphoton ionization (REMPI), and IR-UV double resonance experiments. Density funtional theory (DFT) calculations have been done in conjunction with the experimental work. The first electronic transition of quinine and quinidine is of π-π* nature, and the studied molecules weakly fluoresce in the gas phase, in contrast to what was observed in solution (Qin, W. W.; et al. J. Phys. Chem. C2009, 113, 11790). The two pseudo enantiomers quinine and quinidine show limited differences in the gas phase; their main conformation is of open type as it is in solution. However, vibrational circular dichroism (VCD) experiments in solution show that additional conformers exist in condensed phase for quinidine, which are not observed for quinine. This difference in behavior between the two pseudo enantiomers is discussed.     

Superhydrophobic behaviour of plasma modified electrospun cellulose nanofiber-coated microfibers

In this work, a method is presented for production of a textile cellulose fiber with non-wetting properties suitable for applications ranging from wound care and tissue engineering to clothing and other textile applications. Non-wettability is achieved by coating a textile cellulose microfiber with electrospun cellulose nanofibers, creating a large and rough surface area that is further plasma treated with fluorine plasma. High surface roughness and efficient deposition of covalently bound fluorine groups results in the fiber exhibiting non-wetting properties with contact angle measurements indicating superhydrophobicity (>150° water contact angle). It is an environmentally friendly method and the flexibility of the electrospinning process allows for careful design of material properties regarding everything from material choice and surface chemistry to fiber morphology and fiber assembly, pointing to the potential of the method and the developed fibers within a wide range of applications.     

A photosynthetic biosensor with enhanced electron transfer generation realized by laser printing technology

One of the limits of current electrochemical biosensors is a lack of methods providing stable and highly efficient junctions between biomaterial and solid-state devices. This paper shows how laser-induced forward transfer (LIFT) can enable efficient electron transfer from photosynthetic biomaterial immobilized on screen-printed electrodes (SPE). The ideal pattern, in terms of photocurrent signal of thylakoid droplets giving a stable response signal with a current intensity of approximately 335 ± 13 nA for a thylakoid mass of 28 ± 4 ng, was selected. It is shown that the efficiency of energy production of a photosynthetic system can be strongly enhanced by the LIFT process, as demonstrated by use of the technique to construct an efficient and sensitive photosynthesis-based biosensor for detecting herbicides at nanomolar concentrations.     

Ytterbium triflate catalyzed synthesis of chlorinated lactones

The direct synthesis of chlorolactones from differently substituted alkenoic acids, using either sodium hypochlorite or chloramine T as the source of electrophilic chlorine and ytterbium triflate hydrate as the Lewis acid is described. In both cases the reactions proceeded in good yields affording selectively five- or six-membered chlorolactones.     

A video-optical system for time-resolved whole-body measurement on vascular segments

This paper presents a novel experimental setup to get the three-dimensional (3-D) whole-body deformation of arterial segments under finite inflation and extension. A simple one camera/one shot arrangement allows non-contacting, full-field, real-time measurements to be performed. A concave conical mirror mounted coaxially to the camera provides the whole 360° field view of a large number of closely spaced micro-spheres affixed to the sample surface. Then, on the basis of radial metrology concepts, each single frame of the loading sequence is automatically processed to track 3-D marker positions and, thus, to obtain sample deformation at the camera frame acquisition rate.Preliminary tests are run to evaluate measurement accuracy and to calibrate the system for in-vitro testing in physiological solution. Then, pressure–diameter tests at various levels of axial extension are performed on an excised porcine arterial segment using a specially designed in-vitro rig.Experimental data demonstrate that the present method can provide either global parameters to be used within standard constitutive frameworks and important full-field information on the eventual in-homogeneity of deformation. To better illustrate the latter achievement, results related to the ‘bend buckling’ of a straight porcine vascular vessel tested at low axial stretch are reported. Remarkably, the experimental apparatus can be adapted to a large variety of test protocols and sample geometries.     

On second order differential equations with state-dependent delay

We study existence and uniqueness of solutions for a general class of second order abstract differential equations with state-dependent delay. Some examples related to partial differential equations with state dependent delay are presented.     

Dermal Tattoo Biosensors for Colorimetric Metabolite Detection

Tattooing is a ubiquitous body modification involving the injection of ink and/or dye pigments into the dermis. Biosensors in the form of tattoos can be used to monitor metabolites in interstitial fluid. Here, minimally invasive, injectable dermal biosensors were developed for measuring pH, glucose, and albumin concentrations. The dermal pH sensor was based on methyl red, bromothymol blue, and phenolphthalein, which responded to a pH range from 5.0 to 9.0. The dermal glucose sensor consisted of glucose oxidase, 3,3′,5,5′‐tetramethylbenzidine, and peroxidase that detected concentrations up to 50.0 mmol L^?1. The dermal albumin sensor consisted of 3′,3′′,5′,5′′‐tetrachlorophenol‐3,4,5,6‐tetrabromosulfophthalein to measure concentrations up to 5.0 g L^?1. The sensors were multiplexed in ex vivo skin tissue and quantitative readouts were obtained using a smartphone camera. These sensors can be used to manage of acid–base homeostasis, diabetes, and liver failure in point‐of‐care settings.     

Macrophage Migration Inhibitory Factor (MIF) and Its Homologue D-Dopachrome Tautomerase (DDT) Inversely Correlate with Inflammation in Discoid Lupus Erythematosus

Discoid Lupus Erythematosus (DLE) is a chronic cutaneous disease of unknown etiology and of immunoinflammatory origin that is characterized by inflammatory plaques and may lead to disfiguring scarring and skin atrophy. Current treatments are limited, with a large proportion of patients either poorly or not responsive, which makes DLE an unmet medical need. Macrophage migration inhibitory factor (MIF) is the prototype of a pleiotropic family of cytokine that also includes the recently discovered homologue D-dopachrome tautomerase (DDT) or MIF2. MIF and DDT/MIF-2 exert several biological properties, primarily, but not exclusively of a proinflammatory nature. MIF and DDT have been suggested to play a key role in the pathogenesis of several autoimmune diseases, such as multiple sclerosis and type 1 diabetes, as well as in the development and progression of certain forms of cancers. In the present study, we have performed an immunohistochemistry analysis for the evaluation of MIF in DLE lesions and normal skin. We found high levels of MIF in the basal layer of the epidermis as well as in the cutaneous appendage (eccrine glands and sebocytes) of normal skin. In DLE lesions, we observed a significant negative correlation between the expression of MIF and the severity of inflammation. In addition, we performed an analysis of MIF and DDT expression levels in the skin of DLE patients in a publicly available microarray dataset. Interestingly, while these in silico data only evidenced a trend toward reduced levels of MIF, they demonstrated a significant pattern of expression and correlation of DDT with inflammatory infiltrates in DLE skins. Overall, our data support a protective role for endogenous MIF and possibly DDT in the regulation of homeostasis and inflammation in the skin and open up novel avenues for the treatment of DLE.